Yonkers Signature Drywall frames the walls behind the finish, building straight, plumb partitions ready to receive gypsum board. Good drywall starts with good framing, because no amount of joint compound can hide a wall that bows or racks. We lay out and frame new partition walls, closets, soffits, and full basement build-outs in either metal stud or dimensional lumber depending on the application. Every wall is set true so the board hangs flat and the finish lands right the first time.
Light-gauge metal studs are straight, dimensionally stable, non-combustible, and immune to rot, which makes them the standard for many partition and basement walls. Because they never warp or twist, the finished drywall plane stays flat over time. We track, plumb, and screw metal framing to precise spacing so the board hangs clean and the corners run true.
Dimensional lumber is still the right call where walls carry cabinetry, heavy fixtures, or need solid blocking for future mounting. We frame wood partitions with proper plates, king studs, and headers, adding blocking wherever grab bars, TVs, or shelving will land. Straight, kiln-dried stock keeps the wall from bowing once the drywall goes up.
Finishing a Westchester basement means framing against foundation walls that are often damp and out of plumb. We hold framing off the masonry, use metal studs or pressure-treated bottom plates to resist moisture, and pair the assembly with mold-resistant board on the finish side. The result is a dry, straight, code-conscious wall system built for below-grade conditions.
Hiding ductwork, pipes, and beams cleanly takes careful framing before any board goes up. We build soffits and chases to box in mechanicals and frame new closets and niches squared and plumb. Getting these details right is what lets the drywall wrap around them with tight, consistent corners.
You will find our metal and wood stud framing and partition wall build-outs in Yonkers, NY and neighboring Tuckahoe, White Plains, Scarsdale, Crestwood, and Eastchester.